Help Center - Installation 3

How do I enter my permanent authorization code?

If you see a message telling you you have a certain number of days in which to register, then you are running with a temporary authorization code. If you don't see this message then you already entered the permanent authorization code.

If you are running with a temporary code you can enter the permanent code by clicking on the Register button. This button is found at the bottom of the expiration message. Here are the directions.

If you are using a standalone software do the following...
- Quit/Exit the program if it is already running.
- Launch the program.
- You will see the message telling you how many days you have left.
- At the bottom of this message is a Register button.
- Click the Register button and enter the information it asks for.

If you are using a plug-in do the following...
- Quit/Exit the program if it is already running.
- Launch the host program. (e.g. After Effects, Motion, etc)
- Apply the plug-in to a Solid, or however you normally add it to your project.
- You will see the message telling you how many days you have left.
- At the bottom of this message is a Register button.
- Click the Register button and enter the information it asks for.

Remember, temporary codes are short, about 10 characters long. Permanent codes are long, about 20 characters long.

 

Back to Help Center